Skip to content

PE Foam vs. PET Double-Sided Tape for Signs and Nameplates

Start with the gap behind the part. A sign with a textured back or a shallow recess may need a foam carrier to make contact across the bond area. A thin nameplate on a smooth, flat panel may need a film carrier to keep the edge flush. Check both the sign and the mounting surface before choosing a tape.


Check where the adhesive can make contact


Place the part against the panel without tape. Look for rocking, raised ribs and gaps at the corners. Trial double-sided PE foam tape where the carrier needs to accommodate minor surface variation. Trial double-sided PET tape where the mating surfaces are flat and the finished edge needs a low profile. If either surface is painted or powder coated, test on the actual finish rather than a bare metal substitute.


Reproduce the installation and service conditions


Use representative parts and the same cleaning method, pressure and dwell time for each sample. Install the assemblies in their intended orientation. Check for sliding on vertical panels, edge lift, and marks or gaps visible from the front. Where heat or humidity is expected, repeat the inspection after that exposure. For load-bearing or safety-critical assemblies, use the approved fastening design and qualification procedure.


Send the dimensions and finish with your inquiry


When you request tape samples, include the part dimensions and weight, the finish on each side, the available bond area and the maximum acceptable tape thickness. A side-view drawing showing any recess or ribs helps identify what to sample.

Tell us about your project.

* Required fields

How can we help?